top of page
5 KW ATEX FAN HEATER
ULTRASAFE 233-FA-0056U 5kW, 480V, 3 faz, 7,0A
Elektrikli aparey,  ATEX sertifkalı olup bir çok Rafineri, Kimya fabrikası kullanımına uygun.
ATEX notasyonları;
Class I, Divisions 1 and 2, Groups C and D
Class II, Divisions 1 and 2, Groups E, F and G
Class I, Zones 1 and 2, Group IIB
Temperature Code T3C, 320°F (160°C)

Ultra-Safe TM Exp explosion-proof unit heater is designed with both safety andversatility in mind. Unique Ultra-Safe TM Exp features include :◦Industry's Lowest Ignition Temperature Code Rating : T3C, 320°F (160°C)◦Dual Over temperature Protection: With both automatic and manual reset over temperature cutouts for additional safety.
◦Nontoxic Propylene Glycol Heat Transfer 

Kullanım Alanları:
Aircraft Hangars/Service Areas
Chemical Storage/Handling Areas
Coal Preparation Plants
Compressor Stations
Grain Elevators
Oil Refineries and Rigs
Paint Storage Areas
Petrochemical Plants
Sewage Pump Stations/Treatment Plants
Spray Booths

5 KW ATEX FAN HEATER

  • Kontrol:
    Standard built-in controls include automatic and manual reset over temperature cutouts, controlling magnetic contactor, 24-volt control circuit transformer and incoming power terminal blocks housed in a NEMA 7, 9 cast aluminum enclosure.

    ◦Low 70 PSIG Relief Valve Setting : This assures that in an emergency, the initial escaping vapor temperature remains below the 320°F (160°C) ignition temperature.◦Corrosive Resistant Options : INDEECO offers three constructions suitable for most applications. Standard construction for use in dry non-corrosive areas includes : Welded steel heat exchanger; powder-coated cabinet; epoxy-coated motor. A 316 stainless steel construction suitable for Waste Water Treatment Plants includes : 316 stainless steel heat exchanger, headers and tubes with aluminum fins; stainless steel cabinet; corrosive resistance hardware; epoxy-coated motor. Third construction is suitable for use in Chemical Plants where chlorides are present and includes : Heresite® coated heat exchanger, cabinet, fan blade; corrosive resistance hardware; epoxy-coated motor.

  • Class I, Divisions 1 and 2, Groups C and D
    Class II, Divisions 1 and 2, Groups E, F and G
    Class I, Zones 1 and 2, Group IIB
    Temperature Code T3C, 320°F (160°C)

bottom of page